Pentair LX16 Gear Assembly Back Up Valve

Description

These parts are assorted colors with the gears themselves being white and are housed in the center of the back-up valve, they should be located approximately 30 inches from the head of the cleaner. just make sure you are purchasing the full assembly with the gears included, replacing just the outer case or o-ring for the gears will not correct this issue. These gears are the internal parts of the back-up valve which was designed to be the feature that backs the pressure side cleaner out of any corners or edges on the pool steps which would cause the cleaner to be hung up or impeded in any way thus disrupting. The same materials used to manufacture the original factory part. Without it, the cleaner would be insufficient in its ability to suck and pull up dirt and debris off the surface of your pool. You can do this by pulling it out of the water to see if it's running, it should run for approximately 30 seconds, if it runs longer than this then it means the internal gears have failed and are stuck in the open position ultimately meaning they need to be. These gears are the internal parts of the back-up valve which was designed to be the feature that backs the pressure side cleaner out of any corners or edges on the pool steps which would cause the cleaner to be hung up or impeded in any. Making this a genuine OEM product. It will turn on every 3 minutes and 30 seconds to pull the cleaner out of tight corners or trouble spots.

Key Features

• Without it, the cleaner would be insufficient in its ability to suck and pull up dirt and debris off the surface of your pool.
• The same materials used to manufacture the original factory part.
• One great troubleshooting tip, if the cleaner is tangled up via the hoses or floating at the top of the pool water, would be to check this back-up valve to see if it is operating correctly.
• It will turn on every 3 minutes and 30 seconds to pull the cleaner out of tight corners or trouble spots.
• These gears are the internal parts of the back-up valve which was designed to be the feature that backs the pressure side cleaner out of any corners or edges on the pool steps which would cause the cleaner to be hung up or impeded in any.
• These parts are assorted colors with the gears themselves being white and are housed in the center of the back-up valve, they should be located approximately 30 inches from the head of the cleaner.